Attention: VisualLive is not available for purchase on visuallive.com after May 1, 2023, and can only be purchased through a Unity client partner until June 30, 2023. Maintenance support as outlined in the terms of service ends either May 1, 2024 or one year after purchase; with no new features added and only minor bug fixes supported.
Quick marker scan loading procedure
This is a quicker, easier way to load and place a model with one step. You can also use this method to bring a model that has already been placed into alignment at the location of the marker.
This procedure works well if you have multiple markers in different sections of the model, or different models, and you want to move from one to another and place them quickly.
Prerequisites:
At least one AR marker was added to the model in the VisualLive plug-in.
The printed AR marker is in the corresponding location in the physical site. Accurate positioning of the printed marker on the site is required for good alignment.
Tip: To keep the marker’s direction in your model and in the site consistent, place the virtual and printed AR markers so that the N arrow is vertical. (The arrows do not have to point true north.)
Load and place the model
Switch to AR mode.
Scan the site.
Move to the printed AR marker.
Tap the Scan icon (beside the Load icon).
Scan the AR marker.
For accurate placement:
- Your camera must be within one foot of the marker.
- Scan the paper marker on the site from the front and the side to make sure the virtual compass is fully aligned. Any slight skewing will impact the model more as you move further from the alignment location.
Tap Place Model.
After loading, the model appears in the view. The marker in the model is visible and aligned with the marker on the site.
Additional resources
You can change the position of a virtual marker in your model to align with the printed marker in the site. See Correct the location of an AR marker.