Attention: VisualLive is not available for purchase on visuallive.com after May 1, 2023, and can only be purchased through a Unity client partner until June 30, 2023. Maintenance support as outlined in the terms of service ends either May 1, 2024 or one year after purchase; with no new features added and only minor bug fixes supported.
Move into position
To place or align a model, you must move into position on the site.
Your position during placement
If you use AR markers, reference points, or anchor locks to place a model, move to location on the physical site that corresponds to the alignment option's location in the model.
You must be able to physically access the location on the site. For example, you won't be able to scan an AR marker if equipment at the location prevents you from holding your device within one foot of the marker.
If you are using manual placement, VisualLive for Mobile uses your location on the site as the center of the model's geometry. The model’s placement is relative to you, not the site.
Important: Do not move away from the alignment location until the model is placed.
Placement/alignment method and required proximity
| Alignment option | Required proximity |
|---|---|
| AR markers | Within one foot. |
| Reference points | Close enough to accurately select reference points on the site that correspond to the reference points in the model. |
| Anchor locks | Within a few feet. |
| Two-point alignment | (Manual placement) Close enough to accurately select alignment points in the model and the corresponding points on the site. |