Attention: VisualLive is not available for purchase on visuallive.com after May 1, 2023, and can only be purchased through a Unity client partner until June 30, 2023. Maintenance support as outlined in the terms of service ends either May 1, 2024 or one year after purchase; with no new features added and only minor bug fixes supported.
Fix initial alignment
Depending on the placement options available for your model, fix or fine-tune model placement:
Retry model placement. See Reset model placement.
Bring the model into alignment using the tools in the Align menu.
If your device supports LiDAR, you can place an anchor lock where you have manually aligned the model. The model will pop into alignment as the viewer moves towards each anchor.
If the model is not aligned because an AR marker is placed incorrectly, you can correct the position while you are in AR mode. See Correct the location of an AR marker.
In the VisualLive plug-in, move the existing AR marker and push the model. Reload and place the model.
In the VisualLive plug-in, relocate the two-point-placement reference points by replacing them with new reference points and push the model. Reload and place the model.
Note: Anchor locks and AR markers should not be set closer than 10 feet from each other. If they're closer, they will compete for priority and the model may move erratically as the viewer moves.