Attention: VisualLive is not available for purchase on visuallive.com after May 1, 2023, and can only be purchased through a Unity client partner until June 30, 2023. Maintenance support as outlined in the terms of service ends either May 1, 2024 or one year after purchase; with no new features added and only minor bug fixes supported.

Measure

The Measure feature is available on the bottom feature menu. You can measure the distance between structures and components in your model.

The following options are available in the Measure sub-menu:

Unit

You can switch between the following units of measure:

  • M CM (meter - centimeter)
  • Ft' In" (feet - inches)

Snap

You can line up your measuring tool exactly to the sharp edges or corners on the models or the environment. If you are trying to snap to the environment (not a model), this tool will attempt to snap to the vertices of the scan mesh (which may not be exactly accurate).

Perp.(Perpendicular)

Use this option to measure a straight line between two measuring points. You can measure horizontally or vertically.

**Note: **It's recommended to use the Perpendicular feature in AR mode only.