Smart Platform Audio Management

Understand how SPAM optimizes audio configurations.

阅读时间2 分钟

最后更新于 8 个月前

The Vivox SDK uses Smart Platform Audio Management (SPAM) to automatically select the optimal Android audio configuration based on the context.

注意

Smart Platform Audio Management was known as dynamic voice processing switching (DVPS) in earlier Vivox SDK releases.

SPAM will optimize the audio configuration for voice if both of the following scenarios occur:

The client attempts to access the microphone (for example, when in a session)
The audio is rendered through the built-in speakerphone, or Bluetooth SCO

In all other scenarios, SPAM will optimize the audio configuration for general-purpose audio.

SPAM configuration includes:

The Android AudioManager mode
- When optimizing for voice, this is set to
```
MODE_IN_COMMUNICATION
```
  .
- When optimizing for general-purpose audio, this is set to
```
MODE_NORMAL
```
  .
The OpenSL ES render stream and recording preset
- In voice mode, the render stream is set to
```
SL_ANDROID_STREAM_VOICE
```
  and the recording preset is set to
```
SL_ANDROID_RECORDING_PRESET_VOICE_COMMUNICATION
```
  .
- For general-purpose audio, the render stream is set to
```
SL_ANDROID_STREAM_MEDIA
```
  and the recording preset is set to
```
SL_ANDROID_RECORDING_PRESET_VOICE_RECOGNITION
```
  .
The Bluetooth profile
- In voice mode, when using an audio Bluetooth device, SPAM will use Bluetooth SCO by default, if available. This ensures that the microphone on the Bluetooth device is used to provide the best voice experience for Vivox users.
- When leaving voice mode, SPAM will automatically switch to A2DP and prioritize render audio quality over voice experience. This is configurable; you can change SPAM to always use A2DP by setting the
```
bluetooth_profile
```
  parameter on the SDK config struct.

SPAM also ensures that audio interruptions, such as phone calls, are handled correctly and that Vivox recovers gracefully when the interruption ends. This includes routing to the active audio device and setting up the audio configuration as described earlier in this section.

SPAM is enabled by default. To disable SPAM, perform either of the following actions:

警告

Disabling SPAM is not recommended.

When you initialize the Vivox SDK, configure the
```
dynamic_voice_processing_switching
```
parameter.

After the you initialize the Vivox SDK, call

vx_set_dynamic_voice_processing_switching_enabled()

文档

Development

User Acquisition

Monetization

工业

文档