Voice activity detection

Understand voice activity detection in Vivox.

阅读时间2 分钟

最后更新于 8 个月前

Voice activity detection detects the presence or absence of speech in an application. In most cases, customers do not need to adjust the default voice activity detection (VAD) settings of the Vivox SDK. Before manually tuning the VAD settings, test your setup using Automatically Adjusted VAD. Automatically Adjusted VAD is better at detecting a player speaking than the default VAD settings.

注意

Use

vad_auto

when a player uses the onboard microphone and speakers on PCs and mobile devices. Players using high-quality Bluetooth earbuds, headsets or USB headsets might not benefit from

vad_auto

as many of those devices have built-in noise reduction or directional microphones that already produce a clean voice signal.

Set

vad_auto

to 1 in the

vx_req_aux_set_vad_properties

call to enable automatic adjustment. See the example shown below to enable

vad_auto


vx_req_aux_set_vad_properties_t *req;vx_req_aux_set_vad_properties_create(&req);req->vad_hangover = 2000;req->vad_sensitivity = 43;req->vad_noise_floor = 576;req->vad_auto = 1;vx_issue_request(&req->base);

注意

Although the VAD ignores the other settings when

vad_auto

is enabled, you must provide valid parameters or the call will return an error. This example provides the default values for the

vad_hangover

vad_sensitivity

, and

vad_noise_floor

If the Automatically Adjusted VAD does not help, disable

vad_auto

by setting it to 0 and provide values for

vad_hangover

vad_sensitivity

, and

vad_noise_floor

注意

Changes to the VAD noise floor settings do not affect currently joined channels. If the ability to change VAD settings is available to the end-user, indicate that noise floor changes only take effect in the next voice session or only allow changing the noise floor channel when the client is not in-channel.

文档

Development

User Acquisition

Monetization

工业

文档