Hand Draw
Branches can be drawn by hand using the mouse or a tablet device.
Read time 2 minutesLast updated 2 hours ago
After branches are drawn, they can be manipulated as Bézier splines and even extended by another hand drawing operation. Hand-drawn branches can originate from Tree node (the disk on the ground) or any other branch node (hand drawn or not). Procedural generators can be added to hand-drawn generators, allowing you to be specific where you need to be and still get the benefits of procedural geometry to fill in the details.
Topic | Description |
|---|---|
| Hand draw a branch | Get started with hand drawing branches. |
| Edit the spine of an existing hand drawn branch | Switch to node-editing mode and edit a hand-drawn branch. |
| Convert procedural branches to hand drawing | Convert a procedural branch to a hand-drawn branch. |
| Work with hand drawn generators in the Generation Editor | Ensure that hand-drawn branches are drawn into the correct generator. |
Best practices
The following list outlines a few things to keep in mind when hand drawing branches.
- The "Spine:Noise:Late" noise works on hand drawn branches. Use this to your advantage! Keep your branch drawing smooth and simple and use noise to rough them up. It's a good idea to use the "Round" preset on the noise profile so that the beginning and end of the branch are right where you put them.
- All of the skinning properties still work procedurally. Radius, displacement, welding, etc. are all manipulated in the same manner as regular branches.
- Forces work…if you allow them! They will, however, pull the branch off of the drawn spline.
- You can move the start position and angle using the Art Director gizmo handles. You can also manipulate the properties directly.
- Hand drawn branches work in the subdivision surface system.