Documentation

SpeedTree Modeler

SpeedTree Modeler

Create and edit procedural vines

Create procedural vines with typical shapes and behaviors.
Read time 1 minuteLast updated 7 hours ago

To make manual edits, refer to Place and edit vines manually.

Create procedural vines

To create procedural vines:
  1. Add a Vine generator with one of the following methods:

    Added to a parent generator

    Cast with a Projector

    Added with a Zone generator

    Added to a Branch generator
    Cast with a Projector
    Added with a Zone generator
  2. Create a geometry force from the generators or mesh assets you want the vine to interact with.
  3. Enable the geometry force in the Vine generator properties.
    Note
    The Vine generator must be in a later pass than the generators that make the geometry force.
  4. Adjust the Vine generator properties to get the desired placement and shape.
    Tip
    Increase the Segments:Accuracy to get more detail on the vine and better collisions.
    Tip
    You may find it easier to position the vines over other geometry if you set the Spine:Droop:Style to Off. Once you have a desired position, set Spine:Droop:Style to On to test how the vines fall with gravity.
    Vines positioned with Droop set to off, then turned on

Common behaviors for vines

To create common vine behaviors, use the following properties:

Vine behavior

Properties to edit

Swooping and hanging with gravitySpine:Droop properties
Crawling and wrapping around other geometryGeometry Force Crawling properties
Swooping in-line with a parent branchRefer to Create low-poly vines for games
Following another vine or branchRefer to Create vines that follow a guide

Additional resources