Documentation

SpeedTree Modeler

SpeedTree Modeler

Classic

Classic mode exists to support legacy models.
Read time 3 minutesLast updated 2 hours ago

Classic mode should not be used on current models. Favor Interval, Phyllotaxy, and Bifurcation instead.

Style

Absolute

For Generation:Frequency and Steps:Number, the exact value you enter will be set.
For example, if Generation:Frequency is 3, then 3 nodes will appear. If you then change the Steps:Number to 3, you will get 3 steps on the spine with 3 nodes in each step.

Relative

Generation:Frequency and Steps:Number values are computed based on the length of the parent node.
For example, if Generation:Style is set to relative, this integer becomes a floating point value and the actual number of nodes generated is computed based on the length of the parent. So, if both the Generation:Frequency and the Steps:Number is set to 3, you will get 3 steps on the spine with 3 nodes in each step for the spine length value you have set. However, if the branches are shorter or longer, the node amount for Generation:Frequency and Steps:Number may vary: fewer nodes for a short spine length and more nodes for a longer spine length.

Frequency

Sets the number of nodes generated.

Orientation

Alignment

Specifies how the local up axis aligns with the global up vector from the following options:

Property

Description

NoneNodes have a random orientation.
AlignThe first node in each step is centered vertically on its parent.
Center AlignEach step is re-aligned so the Sweep range is centered vertically on its parent.
Note
If 'Steps' are disabled, the initial generation angle is centered vertically on the parent node instead.

Balanced

Nodes can be balanced (equally spaced) radially by enabling this property.
Note
Changing the Generation:Frequency or Generation:Steps:Number properties will result in positional shifting in order to maintain equal spacing.

Offset

The computed angle for each node is offset [+/-] between 0 and this amount.

Sweep

Defines the arc around the parent node where nodes are eligible.
Note
Balance is applied after the Sweep arc is defined.

Roll

Each node is rotated this absolute amount from its computed angle.

Steps

Enabled

When enabled, nodes are grouped into lengthwise steps along the parent node. Balance, angle offset, and other properties will be applied per step.
Each step contains approximately (Generation: Frequency ÷ Generation: Step: Number) branches.

Number

Determines the number of steps to distribute the computed frequency among.
Note
If Generation:Style is set to relative, the actual number of steps generated is computed based on the length of the parent node.

Spread

The maximum amount of lengthwise node spacing allowed from the center of each step to its extents.

Roll

The amount each step is rolled relative to the previous step.

Per Step Frequency

The number of nodes from the Generation:Frequency value is created per step, rather than the frequency value being distributed among all the steps.

Shared

The Shared properties are common to all generation modes and are documented here.