---
title: Hand Draw
product: SpeedTree Modeler
version: '10'
latest_version: '10'
status: This page documents version 10. The latest version is 10.
canonical: https://docs.unity.com/en-us/speedtree-modeler/10/hand-draw
latest_url: https://docs.unity.com/en-us/speedtree-modeler/10/hand-draw.md
last_updated: 2026-11-19
generated_at: 2026-11-19T15:05:51.348Z
locale: en-us
---

# Hand Draw

> Branches can be drawn by hand using the mouse or a tablet device.

After branches are drawn, they can be manipulated as Bézier splines and even extended by another hand drawing operation. Hand-drawn branches can originate from Tree node (the disk on the ground) or any other branch node (hand drawn or not). Procedural generators can be added to hand-drawn generators, allowing you to be specific where you need to be and still get the benefits of procedural geometry to fill in the details.

> **Note:**
>
> Hand drawing has changed for SpeedTree 8 to reduce misplaced branches and allow for better draw plane manipulation. The new approach is to place stubs and then extend them as much as you'd like as described below.

| **Topic**                                                                                                                     | **Description**                                                       |
| ----------------------------------------------------------------------------------------------------------------------------- | --------------------------------------------------------------------- |
| [**Hand draw a branch**](./hand-draw-a-branch.md)                                                                             | Get started with hand drawing branches.                               |
| [**Edit the spine of an existing hand drawn branch**](./edit-the-spine-of-an-existing-hand-drawn-branch.md)                   | Switch to node-editing mode and edit a hand-drawn branch.             |
| [**Convert procedural branches to hand drawing**](./convert-procedural-branches-to-hand-drawing.md)                           | Convert a procedural branch to a hand-drawn branch.                   |
| [**Work with hand drawn generators in the Generation Editor**](./work-with-hand-drawn-generators-in-the-generation-editor.md) | Ensure that hand-drawn branches are drawn into the correct generator. |

## Best practices

The following list outlines a few things to keep in mind when hand drawing branches.

* The "Spine:Noise:Late" noise works on hand drawn branches. Use this to your advantage! Keep your branch drawing smooth and simple and use noise to rough them up. It's a good idea to use the "Round" preset on the noise profile so that the beginning and end of the branch are right where you put them.
* All of the skinning properties still work procedurally. Radius, displacement, welding, etc. are all manipulated in the same manner as regular branches.
* Forces work…if you allow them! They will, however, pull the branch off of the drawn spline.
* You can move the start position and angle using the [Art Director](./art-director.md) gizmo handles. You can also manipulate the properties directly.
* Hand drawn branches work in the subdivision surface system.
